Hey folks, I am working on my BBSHD conversion and I think I am missing parts. I have what I assume are brake sensors but don''t I need magnets? I am also missing any instructions so this has all been by youtube. I have hydraulic brakes and had jury rigged two sets of brake handles until I found these cables???
I also have a thin 2 wire cable from the motor with a matching cable with two bare connectos. Where does this go - to the battery? It is very thin wire.
Thanks for any help or suggestions!!
III
yes those are hyd brake cutoffs, should come with a pair of magnets to place on the moving part of the lever so that when you pull the brake you trip the brake sensor alert on the display, cutting off the motor. use sandpaper then epoxy to bond the sensor to the 'sweet spot' on the brake. use super glue or epoxy to help secure the magnet in its place. do one sensor at a time until its working consistently. the cables from the motor itself are the main (splits into accessories at your handlebar), gear shift sensor, speed sensor, battery cable, and the thin small connector is for wired headlight (i dont use it, rechargables are great). hope that helps.