I got my bike all hooked up and running, did a short ride and it works. I just need to get use to how everything works . I haven't been able to connect the controller to my pc yet. I think its a driver issue.
This is as far as I got. I'm not sure how to fix though.
This is the best guide for setting the parameters on bbs02 or bbshd. https://electricbike-blog.com/2015/06/26/a-hackers-guide-to-programming-the-bbs02/ Don't get too hung up the technical stuff right off. Just scroll down to the numbers for each setting. Compare to what you have now. Then see if you like the changes as you make them.
sure thing, programming isnt too intimidating, backup your stock profile, load the em3ev black profile, put in your bettery cutoff, full amperage for the motor, and your wheel size. few other settings to change. used these guides here.
I got my bike all hooked up and running, did a short ride and it works. I just need to get use to how everything works . I haven't been able to connect the controller to my pc yet. I think its a driver issue.
This is as far as I got. I'm not sure how to fix though.
Thanks, I'm just about ready to dive in to the setting part , I'm just about done installing all the parts on the bike. And a little wire management.
This is the best guide for setting the parameters on bbs02 or bbshd. https://electricbike-blog.com/2015/06/26/a-hackers-guide-to-programming-the-bbs02/ Don't get too hung up the technical stuff right off. Just scroll down to the numbers for each setting. Compare to what you have now. Then see if you like the changes as you make them.
sure thing, programming isnt too intimidating, backup your stock profile, load the em3ev black profile, put in your bettery cutoff, full amperage for the motor, and your wheel size. few other settings to change. used these guides here.
https://electricbike-blog.com/2015/06/26/a-hackers-guide-to-programming-the-bbs02/
https://edrivenet.com/bafang-programming/