I purchased the cyclone off the johnnynerdout website it did not come with a wire diagram and not all the plugs are marked after plugging in all that would plug in the throttle would light up and show 52 volts but there is a missing wire that goes to the display that is not hooked up so its not starting up the three wire plug for the display is plugged in but there is a two wire yellow and blue that there is nothing to connect to can anyone help ?
top of page
bottom of page
i do have another question if you could help me i have a old huffy mountain bike but when i took the bottom bracket apart it was a one piece with old taper ball bearings do you know the brands of bikes that have the threaded 68mm bottom bracket ? or is there an adapter to make this cyclone fit my old bike ?
thanks i figured it out i did not know i had to hold down the m key to make the display start up motor is running Thanks for helping
It’s probably not connected correctly. Try a different combo with the connectors coming off the display.