DPC-18 will only allow the 5 PAS levels. I have been told that they correspond to Controller settings for 1,3,5 7,9. I was hoping to get a better range with all 9 levels, but unless there is a way to Flash the DPC-18 display, then I guess I am out of luck.
not sure on that display... I use 500c. There may be a setting to set 9 or 5 levels in the display, if not in the controller software. It may show up once you do.
No way to change the number of levels on the new dpc18 that I know of. You can change the assist percent of each level with a programming cable. The 5 levels correspond to levels 2,4,6,8,9
Correct, the newer DPC-18 displays only allow for 5 levels of assist. Hopefully in future versions they change that.
DPC-18 will only allow the 5 PAS levels. I have been told that they correspond to Controller settings for 1,3,5 7,9. I was hoping to get a better range with all 9 levels, but unless there is a way to Flash the DPC-18 display, then I guess I am out of luck.
not sure on that display... I use 500c. There may be a setting to set 9 or 5 levels in the display, if not in the controller software. It may show up once you do.
Following.... Mine does that too.