Just recently purchased the EggRider controller paired with a BBS02 motor. When I try to read the Basic page for programming I get an error code FB-11. any idea what it is and how to solve it? Also is there a factory reset for the EggRide?
top of page
bottom of page
I'm not sure if this will help, but try going into your Display settings and set your Protocol to "Auto" and then try to connect. I was getting read errors when I started mine up for the first time, but I don't remember if the code was the same as the one you received. Anyway for me, I changed the protocol to Bafang as part of the start up process before I tried to connect and I kept getting read errors. When I switched it to "auto" it worked no problem. Plus the Protocol was changed by the controller from Auto To Bafang automatically after the first connection. I haven't had any issues since.